WATERJET CUTTING
CUT VIRTUALLY ANY MATERIAL ON EARTH
Experience unlimited diversity in material shape cutting!
Metals, Rubber, Plastic, Stone, Glass, Composites, Foam, Paper, Gasket Sheet, Wood, Shim Stock, Fiberglass, & More!
SATIN SMOOTH EDGE
No secondary or post-process finishing is required! Your parts will require no additional machining. If high edge quality is not necessary you can save money with faster cutting!
COLD CUTTING PROCESS
When Bluewater Rubber & Gaskets cuts your parts with our waterjet equipment there are no heat-affected zones. Materials maintain their tensile strengths and integrity.
MINIMAL KERF & TAPER
Waterjet cutting can produce intricate parts with extremely high accuracy - even with thick materials including metals!
Cutting material with ultra-high pressure water is an involved process that starts with the same water which comes from our faucet. We soften and purify the water before it even reaches the pump. The FLOW® intensifier shifts back and forth to intake the water which is again filtered by a 1 micron and a .45 micron filter. As the intensifier operates, it converts 3000 PSI hydraulic pressure into 60,000 PSI water pressure. That water moves through high pressure tubing to the cutting head. The cutting head contains an on/off valve that shuts the flow off or on to allow the water to be forced thru a jewel orifice to the material. Waterjet cutting isn't actually cutting; it's eroding the cut path. The result is an extremely effective process acclaimed for speed, accuracy, and cost effectiveness. We invite you to experience the benefits of this remarkable system.
ENDLESS POSSIBILITIES
